How to install the steel ball on the slide rail - The drawer of the steel ball slide rail has been r

Slide rails are commonly used in drawers with bead racks, consisting of inner and middle rails. If the drawer's steel ball slide rail has been removed, it can be challenging to put it back. This article will provide step-by-step instructions on how to reinstall the drawer's steel ball slide rail.

Step 1:

Before installation, pull the bead racks to the bottom of the drawer. Hold the drawer with your hands and simultaneously insert the inner rails on the left and right sides. Apply pressure until you hear a snapping sound, indicating that the rails have entered the slot.

Reasons for a Slipped Drawer and Fallen Ball Strip:

A slipped drawer or fallen ball strip is usually caused by an uneven outer side of the slide rail, improper ground conditions, or improper installation of the slide rail. Each slide rail structure differs, necessitating a detailed analysis of the specific problem.

Specific Methods to Address the Issues:

1. Adjust the slide rails to be parallel, focusing on the inner low point.

2. Ensure even installation of the slide rails. The inside should be slightly lower than the outside since the drawer will be filled with items.

Reinstalling Fallen Balls:

If the steel balls fall off during assembly or disassembly, clean them with oil and reinstall. However, if the balls fall off during use and the component is damaged, early detection is essential for possible repair. Over time, a damaged component may require replacement.

Reinstalling Steel Balls on the Slide Rail:

If the steel balls fall off the slide rail, first remove the inner rail of the drawer sliding cabinet and locate the spring buckle at the back. Press down on both sides to remove the inner rail. Note that the outer rail and middle rail are connected and cannot be separated.

Next, install the outer rail and middle rail on the left and right sides of the drawer's boxes. Finally, install the inner rail on the side panel of the drawer.

Reinstalling Steel Balls on the Linear Slide Rail:

To reinstall the steel balls on a linear slide rail, ensure that all the balls are collected. Apply paste lubricating oil to the rails on both sides of the slide rail. Remove the front end cover and place the slide rail in an empty track. Slowly place the balls back into the rail one by one to restore functionality.

The process of reinstalling a steel ball slide rail in a drawer or linear rail can be accomplished by following the provided guidelines. It is important to address any issues related to a slipped drawer or fallen ball strip promptly to prevent further damage and ensure smooth functionality. Remember to choose the right type of slide rail for your specific needs and properly maintain it for long-lasting performance.